1 PN#2251 - 94&up SN95 Non IRS Sway Bar Instructions Thank you for your purchase of this Hotchkis product. Your Sway bars were designed w
10 8) Place the plastic back around the Hotchkis sway bar and insert the trim pins to hold. 9) Re-check all hardware for tightness. Remove
11 For proper maintenance the bushings should be greased at least once a year (15,000 miles) or whenever excessive squeaking occurs. Use only a non-
12 Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to qualify f
13 This limited warranty is the entire and only warranty for the products and may not be modified or supplemented by any other person or company in a
14 that any repaired or replaced product will be returned to the sender excluding the cost of freight. Warranty related inquires should be sent to t
2 four clips off of the stock bar and retain them to mount the brake line cable back onto the trailing arm later. 4) Use a 18mm socket an
3 6) Use the grease pack provided to apply a thick coat of grease to the sides of the end link bushings and then install the end links over
4 7) Remove the fuel vapor lines from the clips on the front of the gas tank. Use a zip tie to secure the lines up out of the way. There
5 9) With the bar hanging from the end links you can place the u-bolts over the rear axle. Use the tube of Anti-seize included to apply a small
6 12) Make sure the axle is sitting at normal driving height! Now your ready to tighten everything up. Use a 3/4 wrench and ratchet with 3/
7 IMPORTANT! Recheck all hardware after the first five miles and make sure the end link is not rubbing on the gas lines or fuel tank, if there is r
8 1) Look carefully at the current installation. The Hotchkis front sway bar installs in the same location as the stock bar using new end links and
9 6) Use the grease pack provided to apply a thick coat of grease to the new bushings. Place the bushings over the bar with the split towards the r
Comments to this Manuals