Audi Allroad #22815 Front and Rear Sway Bar Kit Installation Instructions Tools Required: Included In Kit: 1) 4-Post Lift or Floor Ram
4/ Remove the four bushing bracket nuts and bolts (13mm wrench) attaching the anti-roll bar brackets to the sub-frame and save. 5/
8/ Apply supplied grease to inner-channeled portion of both rear bushings. (approx. quarter tube per bushing; picture on next page) Then install the
3/ Take a moment and observe the stock front bar and the way in which it is mounted. 4/ Remove the lower end link bolts and nuts (16mm wrench) to
7/ Re-install the bracket nuts and tighten. Use a small portion of blue thread-locker on the end-link bolts, re-install and tighten well. **Note**
Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to qualify f
This limited warranty is the entire and only warranty for the products and may not be modified or supplemented by any other person or company in any f
SANTA FE SPRINGS, CA 90670 Hotchkis Performance will not accept product returns without the RGA number, receipt and the information described above.
Comments to this Manuals