Hotchkis 2221 1997-1999 Dakota 4x4 Sport Sway Bars User Manual

2221 (97-99) / 2247 (00+) 4WD SPORT SWAY BAR SET 97-UP DODGE DAKOTA Thank you for your purchase from our line of Dodge Dakota & Durango su

P/N 2221 (97-99 4WD stock height) / 2247 (00+ 4WD stock height) 97-Up Dakota Sport Sway Bar Set, Parts List Hotchkis P/N Item DescriptionQuantity Per

CHECK OUT WHAT ELSE HOTCHKIS PERFORMANCE OFFERS FOR YOUR 97+ DODGE DAKOTA OR DURANGO!!!  Sport leaf springs to lower your truck! Features an adjust

Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to qualify fo

anyone, is for the sole purpose of identifying them and is not part of the basis of the bargain, and does not constitute a warranty that the products

SANTA FE SPRINGS, CA 90670 Hotchkis Performance will not accept product returns without the RGA number, receipt and the information described above.

3) Use a 15mm socket or wrench to remove the lower bolts holding the sway bar bushing brackets to the front of the frame. Use a 21mm socket or wrench

6) Use the grease pack provided to apply a thick coat of grease to the inside of the round bushings that fit over the ends of the sway bar. 1997-99 v

9) With the position of the bar now determined, you can tighten up the retainer bracket hardware. Use a 21mm socket or wrench to tighten the upper bo

Please call us at (877) 4NO-ROLL if you have any questions regarding the service and installation of your Hotchkis Performance products. INST

5) Use the grease pack provided to apply a thick coat of grease to the sides of the “dog-bone” end links. Fit the greased end links into the brackets

8) Insert the Hotchkis sway bar into the vehicle. “Hook” the driver’s side end of the sway bar around the shock on that side. For vehicles without

9) Rotate the sway bar up to the suspended end links installed in step 5. Use the 3” long bolt from hardware kit #T1712 to connect the end link to th

11) Use a 3/4" socket or wrench to tighten up the bolts holding the end links in place. Torque the hardware to 30 ft/lbs. Make certain that the