Thank you for your purchase from our new line of Mopar parts. Please call us at 877 - 4NO - ROLL if you have any questions regarding the se
7R. Clean Area for Welding Raise the rear of the vehicle and remove the rear wheels. This will allow you go access the outer section of the fram
side edges of the triangle bracket and the reinforcement bracket. Do this for both driver and passenger sides. 9R. Weld Reinforcement Bracke
Weld the bracket to the frame rail as shown below. 10R Paint & Reassemble End Links Once the brackets are welded in place, pai
11R Offset Leaf Springs Owners! If you have installed a 1-1.5” offset leaf spring kit prior or after the installation of the Hotchkis sway b
Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to qualify
CONSEQUENTIAL DAMAGES, OR OTHER INCIDENTAL OR INDIRECT DAMAGES. HOTCHKIS’ MAXIMUM LIABILITY UNDER THIS WARRANTY SHALL IN NO EVENT EXCEED THE PURCH
5F. Remove the Front Stock Sway Bar Fish the stock bar towards the side that the wheel was taken off. The stock sway bar should be able t
7F. Cut Skid Plate If your k-frame has a skid plate you will need to cut the front welds that attach the plate to the k-frame. This will allo
10F Install the Bushings & Brackets Lube the inside surface of the new bushings with the provided grease. Install the bushings on to the ba
Install the new end links in the same fashion as the stock removal. 12F Re-Weld Skid Plate Use a jack to push the skid plate back to it’s
1R. Raise the Vehicle, Remove Rear Bar Installation must be done at ride height. Drive vehicle on to ramps, or use a 4-post a
Lift the sway bar into position, and attach to u-bolts with the axle brackets. Install the nuts onto the u-bolts, but do not completely tighten yet
We’ve noticed on some E-bodies that the distance between the left and right frame rails were ½” wider. If the frame bracket does not line up in
Place the reinforcement bracket onto the frame rail and position the sway bar triangle frame bracket up against the reinforcement bracket. Mark t
Comments to this Manuals