BMW E46 3 SERIES SPORT SWAY BAR SET # 22825 Thank you for your purchase from our new line of BMW E46 parts. Please call us at (877) 4NO - ROLL i
13) Next, fully tighten the jam nut on the end link using an 11/16” open-end wrench. Make sure the heim joint is centered. You may need a flat sc
BMW E46 3 SERIES SPORT SWAY BAR SET # 22825 Hotchkis P/N Item Description Quantity1 22810285 Front Anti Roll Bar 12 22910285 Rear Anti Roll Bar 13
Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to qualify
DESCRIPTION ON THE FACE HEREOF. ANY IMPLIED WARRANTIES ARE DISCLAIMED TO THE FULLEST EXTENT PERMITTED BY LAW. THIS WARRANTY DOES NOT COVER CONSEQUENT
2) Once the vehicle is raised, use a Phillips screwdriver and remove the aero-pan fasteners. Let the pan hang from the front in order to expose the
5) Apply grease along the inside surface of your polyurethane bushings and attach them to the Hotchkis bar in the approximate mounting locations. Sl
7) Re-install the bracket nuts and tighten. The front uses the larger of the 2 brackets we provide. Then re-install the end link ends and nuts on on
INSTALLATION OF HOTCHKIS REAR SWAY BAR 1) Drive the rear of the vehicle onto floor ramps and securely block the front wheels of the vehicle. I
4) Remove the stock bushing brackets on both the driver and passenger sides. 5) The stock rear bar is now free and can be removed as shown below.
7) Again using the stock hardware, install the end links to the cast suspension arms making sure the lower grease fitting points towards the rear of
10) Next, slide the bushing brackets over the bushings. Position the bracket onto the stock mounting point. You will need to install the provided a
12) Adjustable length end links It may be necessary to adjust the length of the end links for proper sway bar clearance from the drive axles. T
Comments to this Manuals