Thank you for your purchase from our new line of Chevy parts. Please call us at 877 - 4NO - ROLL if you have any questions regarding the ser
Next install additional large washers & bushings in the order shown below. Insert the bolt through the a-arm and install the smaller diamete
6F Finish Up Finish the installation by fully tightening the bushing bracket bolts. Double check all hardware for tightness and you are done with
1R Raising Car Raise rear of the vehicle by using a 4 post lift or drive-on ramps. Securely block the front wheels of the vehicle. Do not remove
Use an air chisel to cut the head off and pop out the rivet with a punch. This hole will be your forward hole.
You will need to use the bushing bracket as a template to locate the rearward hole. Place the bracket over the rivet hole and mark the frame for t
3R Mount Sway bar on Frame
Once you have the 2 holes on each frame rail, we can install the sway bar, bushings and brackets. First, grease the inside surface of the D-shaped
4R Connect End Links Now that the bar is in place, we will attach the end links to the sway bar. Using bag#17118-2 hardware and included misalig
With the end links attached to the sway bar, adjust the length of the end links so that the sway bar lever arms are near level when the lower rod e
6R Weld Support Gusset Use hardware bag#17118-3 and mount the support gusset as shown in the picture. Grind away any rust, paint or dirt near th
2F Install Frame Mounts First step is to install the frame mounts. The mounts utilize existing rivet holes in the frame. You will need to air chi
7R Finish Mounting the End Link Use the rest of the hardware from bag#17118-3 to mount the lower end of the end link to the trailing arm as shown i
Check out our other great products for your C10 Pickup at Hotchkis.net - 19390 Sport Coil Springs (4/6 Drop)
- 11390U Tubular Upper A-Arms (Better Camber Curve) - 11390L Tubular Lower A-Arms (Increased Caster for Stability and Cornering Grip) - 30390 Anti-
Effective December 1, 2010 all Hotchkis products must be registered to qualify for warranty at www.hotchkis.net or via the mail-in warranty card, i
limitation of incidental or consequential damages and in such states the above limitations or exclusions may not apply. This limited warranty gives
Once the holes are clear, grab the 3/8” x 1.5” hex bolts & washers from the “front” hardware bag and insert them into the rivet holes facing
Position the mounting bracket to the frame rail and begin fastening the 3/8” bolts with the provided washers and nylock nuts. Do not tighten all t
Grab the 3/8” x 1.25” hex bolts and drop them into the mount holes on the bracket itself. Don’t forget to use washers. You can now fully tig
3F Install Bushings & Brackets Next grease the inner surface of the provided polyurethane bushings and install them onto the sway bar near to t
4F Mount Bar onto Truck Position the sway bar up to the frame mounts. Using the 3/8” hardware from the kit, start fastening the bushing brackets o
Comments to this Manuals