Hotchkis 22435R MX5 Rear Sport Sway Bar User Manual

Browse online or download User Manual for For the car Hotchkis 22435R MX5 Rear Sport Sway Bar. Hotchkis 22435R MX5 Rear Sport Sway Bar User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Thank you for your purchase from our new line of Mazda parts.
Please call us at 877 - 4NO - ROLL if you have any questions
regarding the service or installation of your Hotchkis Performance products.
1F
Raising Vehicle
Removal of the front sway bar should be done at ride height, so it is recommended that the
vehicle be raised by a flat alignment style rack, or place the front of the vehicle on ramps and
securely block the rear wheels.
2F
Remove front Splash Guard
To access the front sway bar you will need to remove the front splashguard. There are a
series of screws and snap clips that hold it in place. Once all the clips and screws are removed
you can set the splashguard aside.
Installation of Hotchkis Front Sway Bar
Sport Sway Bar Kit 22435, 22437
Mazda MX-5, RX-8
Page view 0
1 2 3 4 5 6 7 8 9 10

Summary of Contents

Page 1 - Mazda MX-5, RX-8

Thank you for your purchase from our new line of Mazda parts. Please call us at 877 - 4NO - ROLL if you have any questions regarding the ser

Page 2 - Detach End Links

DAMAGE TO THE VEHICLE OR COMPONENTS OF THE VEHICLE, ANY OTHER TYPE OF CONSEQUENTIAL DAMAGES, OR OTHER INCIDENTAL OR INDIRECT DAMAGES. HOTCHKIS’ MA

Page 3 - Remove the Front Sway Bar

3F Detach End Links Loosen and remove the lower end link nuts from both sides, and push links aside. 4F Disconnect Lower Radiator Supports

Page 4 - Reinstall New Hotchkis Bar

6F Remove the Front Sway Bar It’s a tight fit where the front bar is, so it will take some patience removing the sway bar. To ease removal, tak

Page 5 - Double Check Hardware

7F Reinstall New Hotchkis Bar Repeat steps 1F through 6F in reverse order. Your new Hotchkis bar uses new bushings and brackets. Use the suppl

Page 6 - Raising Car

(Please ignore the hardware shown in the above picture) 8F Double Check Hardware Make sure all hardware is fully tightened before driving th

Page 7

1R Raising Car Removal of the rear sway bar should be done at ride height, so it is recommended that the vehicle be raised by a flat alignment s

Page 8

3R Undo the Sway Bar Bushing Bracket Bolts Loosen and remove the sway bar bushing bracket bolts. There are 2 per bracket. Once the bolts are

Page 9

5R Double Check Hardware Make sure all hardware is fully tightened before driving the vehicle. You are done with the installation. The v

Page 10

Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to quali

Comments to this Manuals

No comments