Hotchkis 19105 300C SRT8 & Charger SRT8 Sport Coil Spri User Manual

Sport Coil Springs 19105 05 Chysler 300C SRT-8 – 05 Dodge Charger SRT-8 Thank you for your purchase from our new line of SRT-8 parts. Plea

9) You should now be able to easily access the stock springs. Keep track of the rubber spring isolators located on the top and bottom of the spring.

12) Once everything is in place, raise the rear axle into position. Do not raise all the way up! You will still need some wiggle room to line up the

Sport Coil Springs 19105 05 Chrysler 300C SRT-8 05 Dodge Charger SRT-8 Hotchkis P/N Item Description Quantity1 19830321 Front Coil Springs 2

Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to quali

THERE ARE NO WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH EXTEND B

3) Loosen the upper control arm ball joint bolt (do not remove yet). Apply some WD-40 or similar penetrating lubricant to soak the tapered stud. Us

6) Open the hood of the vehicle and pop off the plastic shock caps. Once exposed, remove the 3 remaining bolts that hold the shock to the vehicle u

8) Secure the spring/shock assembly in your spring compressor and remove the shaft nut using a 18mm socket. Retain hardware for reinstallation. 9

10) Place your new Hotchkis polyurethane bumpstop into the top hat boot assembly as shown in the picture. 11) Place your new Hotchkis coil s

12) Before compressing the spring, test fit the top hat onto the shock shaft and see if your marks line up. If not, rotate the coil spring until they

INSTALLATION OF HOTCHKIS REAR COIL SPRINGS 1) Secure the front wheels with blocks and jack the rear up until the front wheels are off the

4) Pull back the plastic splash guard and remove the bolt that holds the brake line to the frame using a 10mm wrench or socket. 5) Next, you will

6) Support the rear axle pumpkin housing with a jack. Try to use wood or a rubber pad to cushion the contact point of the jack and housing. Rememb